It is then placed in the press

The plate is attached to the base with adhesive and then the base is locked in the chase. The paper is aligned to the correct specification of the proof and then impressions are taken to see and check ink quality, depth of impression and correct alignment.

Once the proof of your stationery is approved, a negative is made and the negative is placed on a light sensitive photopolymer plastic plate, placed under vacuum and exposed to light. This comes from years of design experience and talent and it sets the tone of your piece.

The plate is then cut to size tat will allow it to fit correctly on the milled aluminum base that will used in the press.

Design plays a crucial role in the look and readability of your personalized stationery.Firstly, letterpress and using it to make invitations is nothing new.

Once the alignment, ink and pressure quality standards are met the run begins for that one piece. We have all heard about letterpress printing and how it is used for letterpress invitations, stationery and birth announcements but what really makes it so special? Let's take an abbreviated look at what it takes to turn out your beautiful letterpress wedding invitations or personalized stationery. It is a very detailed process but the result is a beautifully crafted work of art to many. Too much design can make your letterpress invitation may look Table and Chairs Suppliers too busy and too little can make it plain and lacking.

. It is then placed in the press. In fact letterpress died awhile ago and has been resurected back in the late 90's thanks to Martha Stewart. This process can be tedious. After the correct time has elapsed, the plate is washed in water to remove the unexposed material and then dried. You need to find what works for you. Advanced knowledge of software such as Quark, Photoshop and Illustrator is used to make proofs of the stationery. A typical letterpress wedding invitation of four pieces may take 3-4 hours to print at a leisurely rate. Each piece of the job is then setup in the same way and careful attention is made to maintain ink consistency so all pieces look the same. The plastic is now hard enough to withstand the pressure of the platen press. A first impression is taken to begin setting the project for printing. Once dry, the plate is exposed again to light to harden the material. Personalized stationery may take half that time

comments powered by Disqus